|
Publications
| | Minutes and Presentations of the Spring 2006 Meeting, Aprilber
18-19, 2004
hosted by TACOM, Warren, MI
Full Minutes, unconfirmed, posted
here
Agenda here Presentations
(for which we obtained permission to post):
- Henry O Fuchs Student
Award and Presentation: The Influence of a Taper on the Stress Concentration
Factor of a Shoulder Filleted Shaft Curtis Schmidt, University of Tulsa
- Ground Vehicle Simulation Laboratory Overview, David Gorsich, TACOM, (to
be confirmed whether we can post)
- FMTV Leaf Spring Tests Scott Smith, TACOM, (to be confirmed whether we can
post)
- Analytical Simulation Team efforts in Reliability and Safety Paul
Decker/Kris Argeropoulos, TACOM,(to be confirmed whether we can post)
- Run-flat tire testing at NATC Dariusz Mikulski, TACOM, (to be confirmed
whether we can post)
- Parallelizing Reliability software for use on High Performance Computers,
David Lamb, TACOM, (to be confirmed whether we can post)
- High Strain
Rate Characterization of Engineering Materials Jackie Rehkopf - Ford Motor
Co.
- Fatigue
Limit Assessment of Crankshaft Sections with Inclusion of Residual Stresses
Paul Spiteri, Simon Ho, and Yung-Li Lee - DCX
- Surface
Enhancement Group Report - Jack Champaigne
- Fatigue
Life of GMAW Lap Joints Made with Different Steels Cindy Jiang - AET Integration
- Nonproportional Fatigue of Welded Joints under Variable Amplitude Loading
Yung-Li Lee, Tana Tjhung, and Algernon Jordan - DCX (will not be posted)
- Evaluation of Factors Influencing the Accuracy of
Spot-Weld Fatigue Estimation Using the LBF Approach - Jamison Weirup - Honda
R&D Americas
-
Comparison of probabilistic fatigue analyses - Ed Lu, Honeywell, (to be
confirmed whether we can post)
- Wireless
Sensors for Structural Testing & Fatigue Monitoring
- Steve
Arms, MicroStrain, Inc., (to be confirmed whether we can post)
- Fatigue and Durability Analysis of 8630 Statically
vs. Centrifugally Cast Steel, Jeff Gradman (presented by alph Stephens), U
of Iowa
-
Fatigue testing /analysis of Bolted Structures
- C.-C. Chu, Ford Motor Co.
-
Fatigue Prediction in Cylinder Block Threads - Mike Dejack, Ford Motor Co., (will
not be posted)
- 3D elastic/plastic FEA analysis of the fine and
coarse threads using FEMFAT, Ralph Stephens for Nate Bradley, Univ. of Iowa, (to
be confirmed whether we can post)
- Unique Considerations for Testing Bolts, John
Fragnoli, MNP General Fasteners, GenFAst Manufacturing
- Static and Fatigue Bolt shear Strength
Characterization of 15-5PH Stainless Steel and the Effects of Shot Peening -
Kirk W. Olsen, Lord Corporation, (to be confirmed whether we can post)
Introduction of Weld Challenge V and conclusions on challenge VI
|
